1 KEY

Wet Ink Signature:

  1. When an individual wishes to add wet ink signatures to documents by WORD, follow the steps below.
  2. Use BLUE INK. At times you need to write slow enough so the ink can get well established on the paper so it makes a quality transferable signature.
  3. Use a felt pin where the width of the lines are approximately 1/32 inch wide.
  4. Write your signature three times on a white sheet of paper, start one inch from the left side and write big enough so your signature just reaches the one inch border. then move to the center 1/3 and do the same and again on the bottom 1/3 of the paper in the normal vertical position.

An example of three signatures is below in various formats.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.